|
对于思科路由器的IPV6实测，我们要进行哪些操作呢？具体的配置命令都有哪些呢？下面的文章讲给你详细的介绍，相信此文会对你有所帮助。 #没有配置ipv6地址的接口 r1#sh run int fa1/0 interface FastEthernet1/0 ip address 172.16.12.1 255.255.255.0 duplex auto speed auto end r1#sh ipv6 int bri FastEthernet1/0 [up/up] unassigned FastEthernet1/1 [administratively down/down] unassigned r1(config)#int fa1/0 r1(config-if)#ipv6 addr ? WORD General prefix name X:X:X:X::X IPv6 link-local address X:X:X:X::X/<0-128> IPv6 prefix autoconfig Obtain address using autoconfiguration #配置本地链路地址不成功，因为ipv6的link-local地址必须是fe80::/16开头的 r1(config-if)#ipv6 addr 3333::1 link-local % Invalid link-local address #先配置ipv6 prefix地址 r1(config-if)#ipv6 addr 3333::1/112 r1(config-if)#do sh run int fa1/0 interface FastEthernet1/0 ip address 172.16.12.1 255.255.255.0 duplex auto speed auto ipv6 address 3333::1/112 #配置了prefix地址后，会自动配置link-local r1#sh ipv6 int bri FastEthernet1/0 [up/up] FE80::C800:14FF:FE38:1C 3333::1 FastEthernet1/1 [administratively down/down] unassigned #可以手动配置link-local，覆盖掉自动生成的link-local #一个接口只能有一个link-local，配置多条前面的会被覆盖 #一个接口可配置多条prefix地址 r1(config-if)#ipv6 addr fe80::1 link-local r1(config-if)#ipv6 addr fe80::1:1 link-local r1(config-if)#ipv6 addr fe80::3:1:1 link-local r1(config-if)#ipv6 addr 4444::1/112 r1#sh int fa1/0 interface FastEthernet1/0 ip address 172.16.12.1 255.255.255.0 duplex auto speed auto ipv6 address 3333::1/112 ipv6 address 4444::1/112 ipv6 address FE80::3:1:1 link-local end |